From: Nigel Taylor (nigel_taylor@xxxxxxxxxxx)
Date: Sun May 26 2002 - 08:30:29 GMT-3
Hey Chuck M.
I'm not totally sure of the question you're asking?
There are config examples fpr VoIP which look like the following,
dial-peer voice 3 voip
destination-pattern 816
session target ipv4:172.22.10.1
!
dial-peer voice 4 voip
destination-pattern 81690
session target ipv4:172.22.10.1
Now assume dial-peer 3 is configured for wild-card matching:
dial-peer voice 3 voip
destination-pattern 816..
session target ipv4:172.22.10.1
!
dial-peer voice 4 voip
destination-pattern 81690
session target ipv4:172.22.10.1
Are you referencing the spedific commands used with the "pots" dial-peers or
just VoIP general configuration.
http://www.cisco.com/warp/public/788/voip/in_dial_peer_match.html
http://www.cisco.com/warp/public/788/AVVID/backup_cm.html
HTH
Nigel
----- Original Message -----
From: "Chuck Mason" <romason0916@hananet.net>
To: "CCIE" <ccielab@groupstudy.com>
Sent: Sunday, May 26, 2002 6:44 AM
Subject: Destination patterns
> I see these examples for the POTS dial-peers:
>
> Router(config)> dial-peer voice 1 pots
> Router(config-dial-peer)> destination-pattern not-provided
> Router(config-dial-peer)> port 2
>
> Router(config)> dial-peer voice 1 pots
> Router(config-dial-peer)> port 2
> Router(config-dial-peer)> forward-to-unused-port
>
> Is there something like this for VOIP dial-peers?
> cm
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:09 GMT-3