Re: Ring and Bridge numbers for TR

From: Phil (ciscostudent1@xxxxxxxxxxxx)
Date: Sat May 25 2002 - 00:57:07 GMT-3

• Next message: chenyan: "demand circuit over aux?"
• Previous message: chenyan: "the lab device ios ver?"
• Maybe in reply to: Harish DV/peakxv: "Ring and Bridge numbers for TR"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Yes, you are correct. In the token ring switch you enter the numbers in hex, bu
t be advised that in the cisco routers you enter the values in decimal.
Phil

  Harish DV/peakxv <harish.dv@peakxv.net> escreveu: Hi all..

I know that the ring and bridge numbers in a TR switch are in Hex. So if
you are given to configure a Bridge number of 17 and a ring number of 300 ,
will it be
0x11 and 0x12C is what I need to configure on the switch respectively?.
Can some one clarify this?

Harish

• Next message: chenyan: "demand circuit over aux?"
• Previous message: chenyan: "the lab device ios ver?"
• Maybe in reply to: Harish DV/peakxv: "Ring and Bridge numbers for TR"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:08 GMT-3