From: Jerry Haverkos (jhaverkos@xxxxxxxxxxxxxxx)
Date: Fri May 24 2002 - 17:00:19 GMT-3
My understanding is the following:
If you use "no ip routing" you have just made your router into an expensive
bridge.
If you use crb ('bridge crb") the router acts like two independent devices.
Interfaces defined to the bridge are part of a bridge device and all other
interfaces still have router functionality. (This is much like the dual but
independent functions of a Cisco device running as frame-relay switch and a
router.)
Integrated routing and bridging ("bridge irb") allows the bridged and router
worlds within the single Cisco device to be integrated.
grandpa jerry
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Krucker, Louis
Sent: Friday, May 24, 2002 3:19 PM
To: 'ccielab@groupstudy.com'
Subject: simple question
Hi Group
I have a simple question about bridging IP on a router.
Do i have to enter "no ip routing" to bridge IP on a router?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:08 GMT-3