Re: How to route udp packets from ethernet to serial intf

From: Harish DV/peakxv (harish.dv@xxxxxxxxxx)
Date: Fri May 24 2002 - 15:23:10 GMT-3

• Next message: adrian 36: "Re: Saudi job"
• Previous message: Gary Braver: "3900 Config requirements"
• Maybe in reply to: Ajit Das: "How to route udp packets from ethernet to serial intf"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Try " ip forward-protocol ? " under global -config mode. You have different
options

Harish

                      Ajit Das

                      <ajidas@cisco.com To: CCIElab@groupstudy.com

> cc:

                      Sent by: Subject: How to route udp packe
ts from ethernet to serial intf
                      nobody@groupstudy

                      .com

                      05/24/2002 10:16

                      AM

                      Please respond to

                      Ajit Das

Hi folks,

Can someone tell me how to route udp broadcast packets from ethernet
port to serial intf.

Thanks

• Next message: adrian 36: "Re: Saudi job"
• Previous message: Gary Braver: "3900 Config requirements"
• Maybe in reply to: Ajit Das: "How to route udp packets from ethernet to serial intf"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:08 GMT-3