Re: How i connect 2 IP Ranges without NAT?

From: George Hansen (HansenG@xxxxxxxxxxxxxxxx)
Date: Thu May 23 2002 - 17:40:14 GMT-3

• Next message: Sasa Milic: "Re: DLSW Custom Queueing"
• Previous message: steven.j.nelson@xxxxxx: "RE: RIP Offset List Question"
• Maybe in reply to: Krucker, Louis: "How i connect 2 IP Ranges without NAT?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Set an access-list on Router A that permits all the addresses that exist on Rou
ter B. Policy Route all packets that match the access-list out the interface to
 Router B.

Do the reverse on Router B.

HTH

George Hansen
#8546

>>> "Krucker, Louis" <louis.krucker@sunrise.net> 05/23/02 11:09AM >>>
I try dlsw first but this solution does not work, but why?

I mean "data link switching", can somebody tell me why i cant
bridge simple layer 2 traffic over dlsw? Does dlsw support only
sna and netbios protocol?
I am know am bit confused but may i dont get the point.....
Maybe its not working because both lan interfaces are ethernet
and not tokenring.

• Next message: Sasa Milic: "Re: DLSW Custom Queueing"
• Previous message: steven.j.nelson@xxxxxx: "RE: RIP Offset List Question"
• Maybe in reply to: Krucker, Louis: "How i connect 2 IP Ranges without NAT?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:07 GMT-3