From: Danny.Wang@xxxxxxxxxxxxxx
Date: Wed May 22 2002 - 13:13:43 GMT-3
Hi Dave,
The exactly error i got was:
"Module 5 has an unsupported type: 41".
Just wondering have you ever seen this kind of error before. I did a bunch
of research, still no idea yet.
The only thing i noticed at CCO is the minimum dram requirement.
To upgrade to Version 4.x, need 16 mb dram, version 5.x for 32 mb, version
6.x for 64 mb and so forth.
MADMAN
<dmadlan@qwest.co To: Danny.Wang@alderwoods.
com
m> cc: ccielab@groupstudy.com
, nobody@groupstudy.com
Subject: Re: Cat5000 flash upgr
ade
05/21/2002 02:43
PM
Please respond to
dmadlan
Well these cards are definately supported in 6.3.x. Are you getting
any more detail in the error messages??
If this is a production box I would get back to the previous OS but
first capture a sho tech and sh logg so that you can try and figure out
what went wrong.
Dave
Danny.Wang@alderwoods.com wrote:
>
> Supervisor engine III: WS-X5530, Module part number: WS-X5014 ,
> |d, 10-Mbps, full- or half-duplex ports, 48 RJ-45 connectors; the module
|
> | occupies two slots.
>
>
>
> Thats sounds odd, what is the module part number??
>
> Dave
>
> Danny.Wang@alderwoods.com wrote:
> >
> > After i upgraded the flash from ver 4.(2) to latest ver 6.3 (8 mb
flash,
> 32
> > mb Dram), there was an error poped up when the system reset, it says
> "the
> > mudule has unsupported". One 48 ports ethernet module can't be
recognized
> > by the system.
> > So my question is:
> >
> > I should go back to the old version or is there a way i could upgrade
the
> > module firmware?
> >
> > Please advise!
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:04 GMT-3