From: Tarek Sabry (tsabry@xxxxxxxxxxxxxxxxxxx)
Date: Tue May 21 2002 - 17:58:30 GMT-3
I'm having a hard time following this thread! If I understand correctly,
Dave is correct; split horizon is on, so disable it in order for RIP to
work. If you want to use unicase RIP then go ahead and define neighbors.
Tarek
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Wright, Jeremy
Sent: Tuesday, May 21, 2002 3:33 PM
To: 'dmadlan@qwest.com'; Wright, Jeremy
Cc: 'Mingzhou Nie'; 'ccielab@groupstudy.com'
Subject: RE: rip & split horizon
yes a frame network. but cant you go back and manually turn split horizon on
the interface. obviously this is not real world, im trying to think of every
stupid possible scenario for the lab.
-----Original Message-----
From: MADMAN [mailto:dmadlan@qwest.com]
Sent: Tuesday, May 21, 2002 3:13 PM
To: Wright, Jeremy
Cc: 'Mingzhou Nie'; 'ccielab@groupstudy.com'
Subject: Re: rip & split horizon
is this a frame network were talking about?? If so split horizon is
disable.
Dave
"Wright, Jeremy" wrote:
>
> without neighbor statements though wouldnt split horizon stop it going out
> to the other spoke since it is on the same interface
>
> -----Original Message-----
> From: MADMAN [mailto:dmadlan@qwest.com]
> Sent: Tuesday, May 21, 2002 3:05 PM
> To: Wright, Jeremy
> Cc: 'Mingzhou Nie'; 'ccielab@groupstudy.com'
> Subject: Re: rip & split horizon
>
> Yes, without neighbor statements.
>
> Dave
>
> "Wright, Jeremy" wrote:
> >
> > i understand that. im talking straight physical interfaces. so if the
hub
> > (r1) receives an update from spoke 1(r2) will it forward the update to
the
> > other spoke 2 (r3) if you have neighbor statements at the hub pointing
to
> > the spokes.
> >
> > -----Original Message-----
> > From: Mingzhou Nie [mailto:mnie@yahoo.com]
> > Sent: Tuesday, May 21, 2002 2:07 PM
> > To: Wright, Jeremy; 'ccielab@groupstudy.com'
> > Subject: Re: rip & split horizon
> >
> > whether split horizon is on or not depends on interface type. main
> > interface has it on and subinterface has it off. It has nothing to do
> > with using neighbor or not.
> >
> > --- "Wright, Jeremy" <JA_WRIGHT@admworld.com> wrote:
> > > i understand the concept of rip and split horizon. if you have a hub
> > > and
> > > spoke setup and if you do neighbor statements at the hub pointing to
> > > the 2
> > > spokes will the update get there with split horizon turned on? i dont
> > > have
> > > the equipment in front of me to simulate this right now. thanks.
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > >
> > > ************************
> > > Jeremy Wright
> > > Network Analyst
> > > Archer Daniels Midland
> > > ja_wright@admworld.com
> > > (217)451-4063
> > >
> > > ************************
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:04 GMT-3