From: Muddasar Ahmed (muddasar_ahmed@xxxxxxxxx)
Date: Tue May 21 2002 - 12:35:14 GMT-3
Chris,
By default OSPF selects the best Path. Without going
into Best Path selection criteria I give you the
answer.
Use the maximum-paths command under OSPF (remnote or
recieving routers) to allow more than one path to the
routing table. OSPF allows only equal cost load
balancing. So your type to metric selection is right
the choice in this scenrio.
regards,
Muddasar
--- "Larson, Chris (Contractor)" <Chris.Larson@ed.gov>
wrote:
> I posted this on Thursday or Friday and have not
> gotten any response (which
> is surprising). So I am posting again in hopes
> someone can shed some light.
>
>
> What I would like to do is this:
> We have 2 hub locations where we are provided
> Internet service. These hub
> locations are equal distance for all the remote
> ends. I am trying to put a
> default information originate into OSPF at both hub
> sites so I can get both
> equal costs 0/0 routes on all remote routers
> pointing to both hub locations
> so traffic will be per destination load balanced to
> the sites.
>
> Both sites are equal costs to remotes, and the
> default info originate is
> being done as metric-type 2. Both 0/0 routes show up
> as type 5 in ospf
> database, but only one shows up in route table.
> Shouldn't there be 2 0/0
> routes in the table? Do you know why there isn't?
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:59:03 GMT-3