RE: RARPing on a Cat IOS switch

From: Jason (jgraun@xxxxxxxxx)
Date: Wed May 15 2002 - 20:17:16 GMT-3

   
Yes but the devices are printers, PCs, etc... not cisco gear.

Jason

-----Original Message-----
From: Harish DV/peakxv [mailto:harish.dv@peakxv.net]
Sent: Wednesday, May 15, 2002 6:00 PM
To: jgraun@attbi.com
Cc: ccielab@groupstudy.com; nobody@groupstudy.com
Subject: Re: RARPing on a Cat IOS switch

sh arp - will show you the ip
addresses
of the devices in the same ip subnet as the switch
sh cdp neighbor detail - will show you the ip addresses of all the
devices connected ( if cdp is enabled on all of them)
sh cam dynamic - will show you the mac address to port
number mapping
sh mac - will show you the received
broadcast/multicast and total frames on each port

So to answer your question, the right command is sh cdp neighbor detail

HTH

Harish

                      jgraun@attbi.com

                      Sent by: To:
ccielab@groupstudy.com

                      nobody@groupstudy cc:

                      .com Subject: RARPing on a
Cat IOS switch

                      05/15/2002 01:52

                      PM

                      Please respond to

                      jgraun

Does anybody know how to get the IP address of a device
plugged directly into the switch if all I have is the
mac address?

Thanks

Jason

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:57 GMT-3