From: John Mistichelli (jmistichelli@xxxxxxxxx)
Date: Tue May 14 2002 - 15:04:57 GMT-3
Good question.
You will end up with two routes to the same destination (0.0.0.0/0) in your for
warding table. Packet flow using this prefix is eligible for packet-by-packet l
oad sharing in a round-robin fashion assuming you are process switching each pa
cket. Chances are your router will attempt to do fast switching (default) for
packets going through the router. That is assuming it has not been disabled on
the outbound interface. In that case you will see destination-by-destination lo
ad sharing. Hope that helps.
John
7536
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:56 GMT-3