From: Michael Kilpatrick (mjkilpat@xxxxxxxxx)
Date: Mon May 06 2002 - 22:03:33 GMT-3
I thought the default "be" size was zero.
Mike
----- Original Message -----
From: "D. J. Jones" <meganac@attbi.com>
To: "Michael Kilpatrick" <mjkilpat@yahoo.com>
Sent: Monday, May 06, 2002 8:56 PM
Subject: Re: Generic Traffic Shaping - Fatkid Lab #461
> I read it a little differently Michael. I think it should read
>
> traffic-shape group 101 16000 32000 32000
>
> based upon this syntax:
>
> traffic-shape group access-list bit-rate [burst-size [excess-burst-size]]
>
> For the excess-burst-size, the default is equal to the burst-size
>
> What do you think?
>
>
> ----- Original Message -----
> From: "Michael Kilpatrick" <mjkilpat@yahoo.com>
> To: <ccielab@groupstudy.com>
> Sent: Monday, May 06, 2002 3:55 PM
> Subject: Generic Traffic Shaping - Fatkid Lab #461
>
>
> > In Fatkid Lab #461, can someone please verify the given solution for
item
> #5.
> >
> > Item #5 says:
> > 5. Configure R3 so that users on the Token Ring segment get at least 16K
> of
> > bandwidth, but not more than 32K, for their telnet traffic, and the
> remaining
> > bandwidth for everything else.
> >
> > And the given solution is:
> > interface Serial0
> > traffic-shape group 101 16000 32000 32000 1000
> > access-list 101 permit tcp any any eq telnet
> >
> > Please correct me if I am wrong, but it seems to me that this does
nothing
> to
> > guarantee users get at least 16K of bandwidth. In addition, this
> traffic-shape
> > command would allow bursts up to the 64k access-rate and would apply a
tc
> > interval of 2 seconds which would be very inefficient.
> >
> > I think the solution should read:
> > interface Serial 0
> > custom-queue-list 1
> > traffic-shape group 101 32000 4000 0
> > access-list 101 permit tcp any any eq telnet
> > queue-list 1 protocol ip 1 tcp telnet
> > queue-list 1 default 2
> > queue-list 1 queue 1 byte-count 100
> > queue-list 1 queue 2 byte-count 300
> >
> > Can someone please verify?
> > Thanks alot! Mike
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:51 GMT-3