Re: simple TR switch question

From: Harish DV/peakxv (harish.dv@xxxxxxxxxx)
Date: Mon Apr 29 2002 - 13:54:34 GMT-3

• Next message: steven.j.nelson@xxxxxx: "FW: BGP Synchro (Time to tear your hair out Pete)"
• Previous message: Phil: "Re: Destination NAT"
• Maybe in reply to: Babacar Diop: "simple TR switch question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
1. Yes , the ring number has to be in Hex
2. Is the IP and the default gateway in the same subnet?.

Harish

                      Babacar Diop

                      <babacard2000@yah To: ccielab@groupstudy.com

                      oo.com> cc:

                      Sent by: Subject: simple TR switch quest
ion
                      nobody@groupstudy

                      .com

                      04/28/2002 06:50

                      PM

                      Please respond to

                      Babacar Diop

Group,

1)
When configuring a token ring switch for ring numbers,
i know you enter the ring number for each CRF or just
leave it at auto. But if you decide to enter the ring
number, do you enter in decimal or in Hex.
I just have a little doubt about it.
2) If you configure an ip and default gateway for the
switch, i think i should be able to ping the default
gateway from the switch. I have not been able to get
this to work. Am i right?

REgards

• Next message: steven.j.nelson@xxxxxx: "FW: BGP Synchro (Time to tear your hair out Pete)"
• Previous message: Phil: "Re: Destination NAT"
• Maybe in reply to: Babacar Diop: "simple TR switch question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:22 GMT-3