From: Sonja Koestler (skoestle@xxxxxxxxx)
Date: Mon Apr 29 2002 - 09:51:38 GMT-3
sometimes the command reference is more useful than the samples. look at
this:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/ibm_
r/brprt1/br1dsrb.htm#xtocid112178
hth, sonja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
yakout esmat
Sent: Montag, 29. April 2002 13:58
To: Groupstudy
Subject: RSRB/TL configs
Hi all,
I have an issue here in regards to 'Source-bridge transparent...' command.
If we have the following configs on a router:
source-bridge ring-group 100
source-bridge transparent 100 1000 ? ?
!
interface ethernet 0
ip add 10.1.1.1 255.255.255.0
bridge-group 2
!
interface tokenring 1
ip address 192.168.1.1 255.255.255.0
source-bridge 5 1 100
source-bridge spanning
!
end
If we need to bridge (Translational) between Ethernet and Token ring
interafces on the same router, we will need to use the following command:
'source-bridge trasparent 100 1000 <?> <?>'
100 = virtual ring number (Token ring)
1000= pseudo ring number
<?>= Does this number equals the ehternet bridge-groupe number in this case
(2) ???
<?>= Does this numnber equals the token ring bridge number in this case (1)
???
All the examples I have seen at CCO are confusing because they are using the
same number.
Thanks in advance
Ya
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:22 GMT-3