From: Balaji Siva (bsivasub@xxxxxxxxx)
Date: Wed Apr 24 2002 - 22:12:55 GMT-3
Just as a side note
CAtalyst 6500/4000 can be enabled to tag all vlans (including NATIVE vlan )
set dot1q-all-tagged enable | disable [all]
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/sw_6_3/cmd_ref/s
et_f_l.htm#84381
Not sure about 2950 though.
B
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Hansang Bae
Sent: Wednesday, April 24, 2002 8:15 PM
To: ccielab@groupstudy.com
Subject: Re: Cisco/Omniswitch compatability
At 11:06 AM 4/24/2002 +0100, Shaun Wakelen wrote:
>Does anybody know of any issues when trunnking betweeen a Cisco
>(specifically a 2950) and an Omniswitch? We are using dot1q, but can only
>'talk' across vlan 1 (customer has management on vlan2, and users on vlan1
>as previously setup on the Omniswitch. The Cisco is a new addition)
Remember that Cisco will *not* tag frames on the Native Vlan.
hsb
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:19 GMT-3