From: Dennis (cc13@xxxxxxxxx)
Date: Mon Apr 22 2002 - 19:27:31 GMT-3
I'm not an expert on this but I think in a hunt group you should have the
preference the same for all the members. You can use the dial-peer hunt
command to determine the order of the hunt group selection. See the link
below. If you still have errors, what is the config for the calling side?
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fvvf
ax_c/vvfpeers.htm#xtocid34
Dennis
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Curtis Phillips
Sent: Monday, April 22, 2002 5:19 PM
To: ccielab@groupstudy.com
Subject: Configuring Hunt-group
Hello,
I have been having difficulty getting defining the hunt-group feature
between
FXS ports on voice module.
I have configured the pots peers as follows:
dial-peer voice 1 pots
destination-pattern 4000
port 1/0/0
dial-peer voice 3 pots
preference 1
destination-pattern 4000
port 1/0/1
I get a rapid busy when dialing from a voip peer.
Can anyone identify and issues or tell me what is missing?
Thanks,
Curtis
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:17 GMT-3