From: veerender attri (helloccie@xxxxxxxxx)
Date: Mon Apr 22 2002 - 18:28:21 GMT-3
I think you can do it in 2 ways:
1) using dynamic crypto map. Here is a link which
describe how to set up it !!!
http://www.cisco.com/warp/public/707/ios_804.html
2) If u have public ip addresses say on ur ethernet
side or a pool assigned to by ISP. U can use that on
either on ethernet or loopback address and use this
address to initiate and terminate tunnels.
Command for this is
cyptoma map <some name> local-address x.x.x.x
--- Craig Columbus
<Craig.Columbus@columbusconsulting.com> wrote:
> Is it possible to setup a router to PIX VPN when the
> router is obtaining a
> dynamic WAN interface address (in this case ISDN
> dial-up)?
> If so, has anyone done this? How do you define the
> peer when you don't
> know the peer address? Is it possible to allow any
> host to create a tunnel
> provided that the pre-shared key is known?
>
> Thanks in advance for your comments!
>
> Craig
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:17 GMT-3