From: Jason Sinclair (sinclairj@xxxxxxxxxxxxxxx)
Date: Sun Apr 21 2002 - 21:35:30 GMT-3
Guy,
Can you post the commands you are trying to enter? Remember that in p2p land
you reference everything via the DLCI rather than maps.
Cheers,
Jason Sinclair CCIE #9100
Manager, Network Support Group
POWERTEL
Ground Level, 55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
* sinclairj@powertel.com.au
-----Original Message-----
From: Lupi, Guy [mailto:Guy.Lupi@eurekaggn.com]
Sent: Monday, 22 April 2002 09:51
To: 'Jeffery S Kimes'; ccielab@groupstudy.com
Subject: RE: Bridging Frame-Relay Point-to-Point
Sub-Interfaces
I don't think it is supported on point to point, you can put
the commands on
but it doesn't seem to work. If you find out otherwise I
would like to hear
about it. I tried this last night with no luck.
~-----Original Message-----
~From: Jeffery S Kimes [mailto:kimes@us.ibm.com]
~Sent: Sunday, April 21, 2002 5:26 PM
~To: ccielab@groupstudy.com
~Subject: Bridging Frame-Relay Point-to-Point Sub-Interfaces
~
~
~Can you bridge frame-relay point-to-point sub-interfaces?
~
~I know that you can on a multi-point interface, but can you
on
~point-to-point?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:15 GMT-3