From: Ahmed Mamoor Amimi (mamoor@xxxxxxxx)
Date: Sun Apr 21 2002 - 17:46:44 GMT-3
Can u paste u config ....
and in the mean while check this :
1 - ip address on BVI
2 - if same subnet then no need to do a bvi
3 - bridge x route ip <------ very important command
4 - show interface irb <---- check which interface is in bridge and which is
routing.
And if this dont help then paste ur config.
-Mamoor
----- Original Message -----
From: Lupi, Guy <Guy.Lupi@eurekaggn.com>
To: <ccielab@groupstudy.com>
Sent: Monday, April 22, 2002 12:04 AM
Subject: IRB with OSPF/EIGRP
> I have a setup like below, and I was trying to run OSPF or EIGRP between
the
> two routers that are in the bridge group and the BVI router, but I
couldn't
> get it to work until I used tunnels. Has anyone gotten OSPF or EIGRP
> working with IRB without using tunnels? Thanks.
>
>
>
> r6
> BVI
> / \
> / \
> r3 r4
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:15 GMT-3