From: Geoffrey KIM (Geoffrey.KIM@xxxxxxxxx)
Date: Sat Apr 20 2002 - 01:33:58 GMT-3
Hi Lupi,
As you know, given a NSAP prefix configured in an ATM switch, it will
construct a full NSAP address (i.e., the prefix plus the ESI address you
have configured) and communicate it back to the end system (i.e., your
router).
If you configure the whole NSAP on the end system side then the switch
assumes that you know what you are doing and instead of sending you back
the NSAP address you are supposed to have, it will tell you the NSAP
prefix of the switch for your reference.
Cheers,
Geoffrey
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On
> Behalf Of Lupi, Guy
> Sent: Saturday, April 20, 2002 3:32 AM
> To: 'ccielab@groupstudy.com'
> Subject: ATM ESI and NSAP
>
>
> I am configuring ATM svc's with esi and nsap addresses, and I
> noticed that
> when I configure the esi address only and do a show atm
> ilmi-status I see
> the full NSAP address and (confirmed) after it. When I
> configure the entire
> nsap address and do a show atm ilmi-status, I only see the
> prefix, not the
> entire address. Is this what I am supposed to see? I have
> very little atm
> experience with svc's, so any help is appreciated. Thanks.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:14 GMT-3