From: kris.keen@xxxxxxxxxx
Date: Mon Apr 15 2002 - 22:02:33 GMT-3
Your helpder addresses will be configured under the interface on which your
clients are connected to..
All this is doing is forwarding broadcast addresses to your specified IP
address.
You can use the forward-protocol to specify exactly what ports you wanted
forward...
The ip-dhcp-server I believe is configured under global configuration
mode..
HTH
-----------------------------------------------------------------
Kris Keen - CNE, CCNA, CCNP
Network Support Specialist - Network Systems
Aon Risk Services Australia Limited
(612) 9253 7272
0404862970
E: Kris.Keen@aon.com.au
"Alex Paulino"
<Alex@2s.com.b To: <ccielab@groupstudy.com>
r> cc:
Sent by: bcc:
nobody@groupst Subject: Ip helper-address in DHCP
Relay
udy.com
15/04/2002
09:21 PM
Please respond
to "Alex
Paulino"
Folks, using the follow "topology":
--R0_Eth0--| Router0 | -R0_S0-------------PPP--------------R1_S0 | Router1
|
-----R1_Eth0
I just have configured DHCP server on Router 0, and i have dhcp Wks clients
in
R1_Eth0.
My question is: Where i must to configure the "ip helper-address X.y.z.w"
command and "ip dhcp-server x.y.z.w" command for suplly the ip address to
Workstations on R1_eth0 ?
thanks
alex
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:08 GMT-3