From: kris.keen@xxxxxxxxxx
Date: Sun Apr 14 2002 - 20:05:45 GMT-3
I would be checking your MAJOR interface is up before your subinterfaces.
Also ensure your LMI counts are raising, "show interface" can help you
here, If LMI is active. Make sure your encap is set, clockrate set on the
DCE end and your LMI is functioning, should work fine..
Regards
-----------------------------------------------------------------
Kris Keen - CNE, CCNA, CCNP
Network Support Specialist - Network Systems
Aon Risk Services Australia Limited
(612) 9253 7272
0404862970
E: Kris.Keen@aon.com.au
"Erick B."
<erickbe@yahoo To: Bill Mckenzie <bmckenzie@hotma
il.com>, ccielab@groupstudy.com
.com> cc:
Sent by: bcc:
nobody@groupst Subject: Re: Can't bring subinterf
ace up in Frame Lab
udy.com
15/04/2002
08:36 AM
Please respond
to "Erick B."
Hmm, is the LMI type correct, and is it configured for
the correct PVC/DLCIs? Frame switch config ok?
Do a 'show frame pvc' and see what the status is of
the PVC.
--- Bill Mckenzie <bmckenzie@hotmail.com> wrote:
> I am having trouble bringing a subinterface to up/up
> state. This is a spoke
> router and if I do a no shut, the interface will
> come up for a moment and go
> right back down again.
>
> Any help?
>
> Thanks,
> Bill Mckenzie
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:58:08 GMT-3