From: Nicolai Gersbo Solling (nicolai@xxxxxxxxx)
Date: Sun Apr 07 2002 - 13:35:11 GMT-3
I have the following Scenario:
R5---Vlan 10---Switch---Vlan40---R6
I wan't to bridge IP between R5 and R6...
...but I am a bit in doubt of which bridge protocol to use:
R5 is a standard configuration and the switch has it's sc0 in Vlan 40.
I have configured R6 (The router that actually takes care of the bridging)
with the following:
bridge 1 protocol vlan-bridge
bridge 1 route ip
bridge 1 route ipx
!
interface FastEthernet0.10
encapsulation isl 10
no ip redirects
bridge-group 1
!
interface FastEthernet0.40
encapsulation isl 40
no ip redirects
bridge-group 1
!
interface BVI1
ip address 137.22.12.6 255.255.255.0
no ip redirects
standby ip 137.22.12.2
standby priority 126
standby preempt
I got the config working now, but I had some strange problems getting it to
work...
I got Encapsulation failed on R5 when I tried to ping R6 - Both the
Mac-table of the switch and the Arp-cache of R6 looked good, but I could
just not resolve on R5...
Then I tried reloading R6 - This did not help...Somehow something was wrong
in the switch - After giveing that a good old powercycle - It works like a
charm...
Any good, and bright ideas why I encountered this...
And is it Vlan Bridging I need to use?
Nic
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:58 GMT-3