From: Jason Gardiner (gardiner@xxxxxxxxxx)
Date: Mon Apr 01 2002 - 16:38:25 GMT-3
Remember that protocol DLSW is only used for FST. Otherwise if you're using
TCP, you need to have an access list specifying the ports 1981, 1982, 1983
and 2065, I believe.
On Monday 01 April 2002 14:07, Todd Carswell wrote:
> Carl,
>
> I forgot to address the rest of your custom queue list...
>
> Here's what you were using:
>
> queue-list 1 protocol ip 0
> queue-list 1 protocol bridge 2
> queue-list 1 protocol dlsw 3
> queue-list 1 queue 1 byte-count 6000 limit 2048
> queue-list 1 queue 2 limit 512
> queue-list 1 queue 3 limit 256
>
>
> Here's what I think you need to use:
>
> queue-list 1 protocol ip 1
> queue-list 1 protocol bridge 2
> queue-list 1 protocol dlsw 3
> queue-list 1 queue 1 byte-count 6000
> queue-list 1 queue 2 byte-count 3000
> queue-list 1 queue 3 byte-count 3000
>
> In your config, you assigned ip to queue 0 when it should have been
> assigned to queue 1 to make it match the rest of the queue-list commands.
>
> Hope that helps!
>
> Todd
>
>
>
> ----- Original Message -----
> From: "Carl Phelan" <carlphelan@hotmail.com>
> To: <ccielab@groupstudy.com>
> Sent: Monday, April 01, 2002 12:07 PM
> Subject: Custom Queueing
>
> > Hi All,
> >
> > Can anyone tell me if this custom queue list is ok to allocate 50% of
> > bandwidth to IP, 25% to bridging and 25% to dlsw considering IP has a
> > packet size of 2048, bridging a packet size of 512 and dlsw a packet
> > size of 256?
> >
> >
> >
> > queue-list 1 protocol ip 0
> > queue-list 1 protocol bridge 2
> > queue-list 1 protocol dlsw 3
> > queue-list 1 queue 1 byte-count 6000 limit 2048
> > queue-list 1 queue 2 limit 512
> > queue-list 1 queue 3 limit 256
> >
> > Many thanks,
> >
> > Carl
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:51 GMT-3