From: Brian Lodwick (xpranax@xxxxxxxxxxx)
Date: Thu Mar 28 2002 - 22:04:58 GMT-3
Try:
show controllers cbus
That'll give you information similar to what you would normally see on like
a 2500.
>>>Brian
>From: "MOLINA, MARTIN J *Internet* (PBI)" <mm1343@pbi.net>
>Reply-To: "MOLINA, MARTIN J *Internet* (PBI)" <mm1343@pbi.net>
>To: "'Armand D'" <ciscoworks2001@yahoo.com>, ccielab@groupstudy.com
>Subject: RE: SHOW CONTROLLERS ON 7513
>Date: Thu, 28 Mar 2002 14:51:30 -0800
>
>If you issue a "sh controllers ?" you will see:
>
> atm ENHANCED ATM PA framer information
> cbus Cbus interface internal state
> fddi FDDI interface internal state
> pos POS framer state
> serial Serial interface internal state
> srp SRP framer state
> t3 T3 controller internal state
> vip Show vip-card related information
> | Output modifiers
>As you can see, you have a couple of options. I believe "sh controllers"
>with no argument specified will retrieve T3 controller info only (if
>installed). Good luck.
>-----Original Message-----
>From: Armand D [mailto:ciscoworks2001@yahoo.com]
>Sent: Thursday, March 28, 2002 1:59 PM
>To: ccielab@groupstudy.com
>Subject: SHOW CONTROLLERS ON 7513
>
>
>Hi,
>
>Does anyone know why on a cisco 7513/RSP4-IOS 12.0(9)
>the show controllers command would not work ?
>
>gw-slcc-7513#show controllers
>gw-slcc-7513#
>
>Any info would be appriciated.
>
>Thanks,
>
>Armand
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:24 GMT-3