From: Curtis Phillips (cphillips@xxxxxxxxxxxx)
Date: Sun Mar 24 2002 - 09:50:44 GMT-3
How are you applying the filter?
It should be applied on an inbound route-map in the neighbor statement to
the router(s) sourcing the community you want to filter.
----- Original Message -----
From: "Shadi" <ccie@investorsgrp.com>
To: "Jack Oscar" <jack_oscar2000@yahoo.com>
Cc: "ccielab" <ccielab@groupstudy.com>
Sent: Saturday, March 23, 2002 11:42 AM
Subject: Re: BGP Community.....strange!!!
> of course send community is configured but when I filter the bgp table, it
> does not filter the community 300:190. it show me all.
>
> anybody have any solution!!!
>
>
>
> ----- Original Message -----
> From: "Jack Oscar" <jack_oscar2000@yahoo.com>
> To: "Shadi" <ccie@investorsgrp.com>
> Sent: Saturday, March 23, 2002 5:38 PM
> Subject: Re: BGP Community.....strange!!!
>
>
> > Have you used the
> >
> > neighbor n.n.n.n send-community
> >
> > command?
> >
> >
> > Also, is your reg exp OK?
> >
> > If you write what are you trying to do, I could suggest an alternative
> >
> >
> > Regards
> >
> >
> > ----- Original Message -----
> > From: "Shadi" <ccie@investorsgrp.com>
> > To: "ccielab" <ccielab@groupstudy.com>
> > Sent: Friday, March 22, 2002 4:27 PM
> > Subject: BGP Community.....strange!!!
> >
> >
> > > Hi all,
> > >
> > > I have a strange problem here, I am trying to filter based on
community
> > > lists,
> > > below you can find my community-list
> > >
> > > ip bgp-community new-format
> > >
> > > ip community-list 1 deny 300:190
> > > ip community-list 1 permit internet
> > >
> > > whenever I do sh ip bgp community-list 1 it shows me all the bgp
routes
> > even
> > > the routes with 300:190 community, so why is that!!!!!???
> > >
> > > Shadi
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:20 GMT-3