From: Vincent Lee (mcne95@xxxxxxxxx)
Date: Fri Mar 15 2002 - 14:49:23 GMT-3
We are using the PacBell and already ordered the Qwest
Circuit.
Two perimeter routers configed with HSRP and they are
only connect to Pacbell at this moment.
We are going to keep PacBell as secondary with a
smaller bandwidth. Qwest will be the primary inbound
Web traffic.
My first step is asking PacBell and Qwest for AS
peering info then I'll apply for our own AS from ARIN.
thanks
--- Brian Lodwick <xpranax@hotmail.com> wrote:
> I would suggest you replace the Qwest circuit with
> another provider so that
> you get some support if it goes down.
>
> >>>Brian
>
>
> >From: MADMAN <dmadlan@qwest.com>
> >Reply-To: MADMAN <dmadlan@qwest.com>
> >To: Vincent Lee <mcne95@yahoo.com>
> >CC: ccielab@groupstudy.com
> >Subject: Re: OT: Change primary ISP from PacBell to
> Quest
> >Date: Fri, 15 Mar 2002 09:35:29 -0600
> >
> > You mean Qwest ;)
> >
> > Reading between the lines are you currently
> connected to PacBell? If
> >so I would set up the BGP connection with them
> first, make sure they get
> >rid of the static routing of your network. Bring
> up the Qwest
> >connection. Then you could establish the IBGP
> connection between the
> >two. Are you doing HSRP between the two routers
> that you defaulting to
> >internally?
> >
> > Just a couple of ideas based on limited info.
> >
> > Dave
> >
> >Vincent Lee wrote:
> > >
> > > I am going to setup a redundancy multihomed BGP
> > > network with two separate ISPs - PacBell and
> Quest.
> > >
> > > Here is my plan.
> > >
> > > 1. setup BGP in our company's perimeter routers
> > >
> > > 2. connect to Pacbell and Quest autonomous
> system
> > >
> > > 3. Change primary DNS server from PacBell to
> Quest in
> > > Network Solutions/VeriSign
> > >
> > > 4. Change our Web IP address in Network
> > > Solutions/VeriSign and point smtp relay
> servers to
> > > Quest.
> > >
> > > Any suggestions are welcome and appreciated.
> > >
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:09 GMT-3