From: Lupi, Guy (Guy.Lupi@xxxxxxxxxxxxx)
Date: Wed Mar 13 2002 - 00:12:18 GMT-3
I had some strange issues a while back, I loaded 12.1(12) on both ISDN
routers and I haven't had a problem since. I had issues with multilink, and
intermittent IP connectivity when connected using multilink or just one b
channel.
-----Original Message-----
From: Ramachandra Shenoy N
To: dmadlan@qwest.com; bhishambajaj@yahoo.com; 'Michael C. Popovich';
Ian.C.Stong@mail.sprint.com
Cc: ccielab@groupstudy.com
Sent: 3/12/2002 6:03 PM
Subject: ISDN Multilink issue....
Thanks for the response guys, I have tried with one dialer map line, I
have set the threshold to 3, also tried setting the dialer threshold to
1 on both the routers, but still that darn thing is adamant and wont
bring up the second line. The failures in the sh dialer command given
below was I guess, due to the various combinations I was trying on the
router, I connect each time I ping the other side invariably. Attached
are the outputs for references.
Thanks and Warm Regards
Ramachandra Shenoy N
Sh isdn status:
Global ISDN Switchtype = basic-ni
ISDN BRI0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 65, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI = 64, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 65, ces = 1, state = 5(init)
spid1 configured, no LDN, spid1 sent, spid1 valid
Endpoint ID Info: epsf = 0, usid = 1, tid = 1
TEI 64, ces = 2, state = 5(init)
spid2 configured, no LDN, spid2 sent, spid2 valid
Endpoint ID Info: epsf = 0, usid = 1, tid = 1
Layer 3 Status:
1 Active Layer 3 Call(s)
CCB:callid=81C5, sapi=0, ces=1, B-chan=1, calltype=DATA
Active dsl 0 CCBs = 1
The Free Channel Mask: 0x80000002
Total Allocated ISDN CCBs = 1
sh dialer
BRI0 - dialer type = ISDN
Dial String Successes Failures Last DNIS Last status
3847201 44 279 00:00:00 failed
0 incoming call(s) have been screened.
0 incoming call(s) rejected for callback.
BRI0:1 - dialer type = ISDN
Idle timer (60 secs), Fast idle timer (20 secs)
Wait for carrier (2 secs), Re-enable (15 secs)
Dialer state is multilink member
Dial reason: ip (s=150.100.5.1, d=150.100.15.33)
Connected to 3847201 (r2)
BRI0:2 - dialer type = ISDN
Idle timer (60 secs), Fast idle timer (20 secs)
Wait for carrier (2 secs), Re-enable (15 secs)
Dialer state is idle
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:57:02 GMT-3