From: tom cheung (tkc9789@xxxxxxxxxxx)
Date: Sat Mar 09 2002 - 15:48:05 GMT-3
I believe you should either add network 172.16.0.0 under r1's eigrp process
or redistribute connected.
>From: "ying chang" <ying_c@hotmail.com>
>Reply-To: "ying chang" <ying_c@hotmail.com>
>To: ccielab@groupstudy.com
>Subject: eigrp stub connected routes?
>Date: Sat, 09 Mar 2002 13:04:24 -0500
>
>This is my first time to setup eigrp stub connected by following the
>example
>in Solie's book pp 710-712. My topology is quite simple, R1 is a stub/spoke
>router and has connected network in 172.16.x.0/24, it connects to R2 via
>192.168.1.0/24, R2 is a distribution/hub router, it has connected network
>192.168.x.0/24. I have no problem to redistribute 192.168.x.0 to R1 via
>redistribute connected commands, but have trouble to see any connected
>routes coming from R1 via "eigrp stub connected" command. R2's "show ip
>eigrp nei detail" said "Stub Peer Advertising ( CONNECTED ) Routes", but
>why
>they are not shown in "show ip eigrp topology" or "show ip route"?
>
>Config and output are at below.
>
>Thanks,
>Chang
>
>Topology:
>
>172.16.x.0/24--R1(stub)--192.168.1.0 EIGRP--R2--192.168.[23].0
>
>Router 1:
>router eigrp 100
>network 192.168.1.0
>default-metric 1544 100 255 1 1500
>no auto-summary
>eigrp stub connected
>no eigrp log-neighbor-changes
>!
>-------------------------------------------------------
>Router2:
>!
>router eigrp 100
>redistribute connected metric 1544 100 255 1 1500
>network 192.168.1.0
>no auto-summary
>no eigrp log-neighbor-changes
>!
>
>--------------------------------------------------------
>Output see from R1 (stub router):
>
>Interfaces:
>
>Interface IP-Address OK? Method Status
>Prot
>ocol
>Ethernet0 172.168.1.1 YES manual up
>up
>
>Ethernet1 unassigned YES NVRAM administratively down
>down
>
>Loopback0 172.168.2.1 YES manual up
>up
>
>Loopback1 172.168.3.1 YES manual up
>up
>
>Loopback2 172.168.4.1 YES manual up
>up
>
>Serial0 192.168.1.1 YES manual up
>up
>
>Serial1 unassigned YES NVRAM administratively down
>down
>
>Routing table:
>
> 172.168.0.0/24 is subnetted, 4 subnets
>C 172.168.4.0 is directly connected, Loopback2
>C 172.168.1.0 is directly connected, Ethernet0
>C 172.168.2.0 is directly connected, Loopback0
>C 172.168.3.0 is directly connected, Loopback1
>C 192.168.1.0/24 is directly connected, Serial0
>D EX 192.168.2.0/24 [170/2195456] via 192.168.1.2, 00:00:07, Serial0
>D EX 192.168.3.0/24 [170/2195456] via 192.168.1.2, 00:00:07, Serial0
>r1#sh ip eigrp nei detail
>IP-EIGRP neighbors for process 100
>H Address Interface Hold Uptime SRTT RTO Q Seq
>Type
> (sec) (ms) Cnt Num
>0 192.168.1.2 Se0 12 00:00:25 36 216 0 6
> Version 12.1/1.2, Retrans: 2, Retries: 0
>--------------------------------------------------------
>Output see from R2 (Distribution router)
>
>Interfaces:
>
>Interface IP-Address OK? Method Status
>Prot
>ocol
>Ethernet0 192.168.2.1 YES manual up
>up
>
>Ethernet1 192.168.3.1 YES manual up
>up
>
>Serial0 unassigned YES manual up
>up
>
>Serial1 192.168.1.2 YES manual up
>up
>
>Routing table:
>C 192.168.1.0/24 is directly connected, Serial1
>C 192.168.2.0/24 is directly connected, Ethernet0
>C 192.168.3.0/24 is directly connected, Ethernet1
>r2#sh ip eigrp nei detail
>IP-EIGRP neighbors for process 100
>H Address Interface Hold Uptime SRTT RTO Q Seq
>Type
> (sec) (ms) Cnt Num
>0 192.168.1.1 Se1 12 00:02:00 1 3000 0 2
> Version 12.1/1.2, Retrans: 1, Retries: 0
> Stub Peer Advertising ( CONNECTED ) Routes
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:58 GMT-3