From: Darren Ward (dward@xxxxxxxxxx)
Date: Mon Mar 04 2002 - 00:55:19 GMT-3
It's to do with the number of controller/channel devices supported on the
WIC carrier card physically.
The 1E's simply don't have the controllers available to support a 2 port
WIC, goes for the A/S's, T's and the CT1/CE1's as well.
Darren Ward
(PGradCS, CCIE #8245, CCNP, CCDP, MCP)
On Sun, 3 Mar 2002, Patrick wrote:
> Thanks,
>
> I found that on Cisco's site after I posted?
>
> It's kinda lame that this is the only cards not supported. I have four
> serial cards in it now so I had one of the tech put in the WIC-2T so I could
> add more ports and he could not make it work.
>
> Back to the drawing board on that one. :)
>
> Patrick
> ----- Original Message -----
> From: "Dotun Oni" <dot_oni@hotmail.com>
> To: <pjm@roadrunner.nf.net>; <ccielab@groupstudy.com>
> Sent: Sunday, March 03, 2002 11:29 PM
> Subject: Re: WIC-2T not working
>
>
> > Patrick,
> >
> > The problem is not the version of IOS. It has to do with the hardware.
> > WIC-2T will not work in a 3640 with a NM-1E2W. It will work the following
> > modules:
> >
> > NM-1FE2W,
> > NM-1FE1R2W,
> > NM-2FE2W,
> > NM-2W
> >
> > OR
> >
> > Swap the WIC-2T out for a WIC-1T if you can get by with one serial port.
> >
> > D
> >
> > >From: "Patrick" <pjm@roadrunner.nf.net>
> > >Reply-To: "Patrick" <pjm@roadrunner.nf.net>
> > >To: <ccielab@groupstudy.com>
> > >Subject: WIC-2T not working
> > >Date: Sun, 3 Mar 2002 22:33:27 -0330
> > >
> > >Anyone know why a WIC-2T will not work in a 3640 with a NM-1E2W?
> > >
> > >The software is 12.1(1)T??
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:52 GMT-3