From: Ouellette, Tim (tim.ouellette@xxxxxxx)
Date: Sun Mar 03 2002 - 21:37:15 GMT-3
John,
the summary-address command never worked anyways. It's a leftover of
bgp3/egp (I think). BGP only uses the aggregate-address command unlike OSPF
where you can use your "area xx range" or summary commands.
hope that helped.
-----Original Message-----
From: John Neiberger [mailto:neiby@ureach.com]
Sent: Sunday, March 03, 2002 12:30 AM
To: ccielab@groupstudy.com
Subject: Summarization?? What's that? (bug report)
While attempting to summarize some prefixes in BGP I got the
following:
R3#conf t
Enter configuration commands, one per line. End with CNTL/Z.
R3(config)#router bgp 2010
R3(config-router)#summa?
% Unrecognized command
R3(config-router)#summar?
% Unrecognized command
R3(config-router)#summar
^
% Invalid input detected at '^' marker.
R3(config-router)#?
Router configuration commands:
address-family Enter Address Family command mode
aggregate-address Configure BGP aggregate entries
auto-summary Enable automatic network number
summarization
bgp BGP specific commands
default Set a command to its defaults
default-information Control distribution of default
information
default-metric Set metric of redistributed routes
distance Define an administrative distance
distribute-list Filter networks in routing updates
exit Exit from routing protocol configuration
mode
help Description of the interactive help
system
maximum-paths Forward packets over multiple paths
neighbor Specify a neighbor router
network Specify a network to announce via BGP
no Negate a command or set its defaults
redistribute Redistribute information from another
routing protocol
synchronization Perform IGP synchronization
table-map Map external entry attributes into
routing table
timers Adjust routing timers
R3(config-router)#
I'm thinking it might be tough to do summarization when the
freaking command is missing!!
This is a 2500 running 12.1(11) Enterprise Plus. Too weird. I
didn't find a bug report for it on CCO but I can't be the only
person to run into this.
Since I don't feel like doing un upgrade right now, I'll skip
that part. <g>
John
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:51 GMT-3