From: alain faure (alainfaure@xxxxxxxx)
Date: Sat Mar 02 2002 - 11:53:48 GMT-3
Hi,
well, new day, new pbm.
r1----ripv2----(nat outside) @13.1.13.3 r3(nat inside)-----ospf----r6
I suppose maybye it can be related to the thread about nat strange behavior.
I a not very used to nat.
Ok,
on r6 there is a loopback 116.1.1.1
on r1 there is a loopback 115.1.1.1
on r3 i put :
router rip
redistribute ospf 1
network 13.1.0.0
default-metric 1
distribute-list nonatnetwork out Serial0/0
!
ip nat inside source static network 116.0.0.0 117.0.0.0 /8
ip nat inside source static network 112.0.0.0 113.0.0.0 /8
ip classless
ip http server
ip pim bidir-enable
!
!
ip access-list standard nonatnetwork
deny 112.0.0.0 0.255.255.255
deny 116.0.0.0 0.255.255.255
permit any
!
So 112.0.0.0 and 116.0.0.0 are nated to respectivly 113.0.0.0 and 117.0.0.0.
112.0.0.0 and 116.0.0.0 routes are not going to r1 on witch i put a policy
routing.
On r1:
router rip
version 2
timers basic 30 180 0 240
network 13.1.0.0
network 115.0.0.0
network 150.50.0.0
no auto-summary
!
ip local policy route-map TONAT
ip kerberos source-interface any
ip classless
ip http server
!
!
ip access-list extended tonat
permit ip any 113.0.0.0 0.255.255.255
permit ip any 117.0.0.0 0.255.255.255
permit ip any 112.0.0.0 0.255.255.255
permit ip any 116.0.0.0 0.255.255.255
route-map TONAT permit 10
match ip address tonat
set ip next-hop 13.1.13.3
---------------------------------------
well, when i ping 116.1.1.1 it ok
R1#ping 116.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 116.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/32 ms
R1#ping 113.1.1.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 113.1.1.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 32/32/36 ms
-----------------------------------
but, and that's the point when i made a DSLW peer or telnet 116.1.1.1 that
don't work.
R1#telnet 116.1.1.1
Trying 116.1.1.1 ...
% Destination unreachable; gateway or host down
----------------------------------------------
On r3 :
R3#telnet 116.1.1.1
Trying 116.1.1.1 ... Open
User Access Verification
Password:
----------------------------------------------
Some body have an explanation for that or a clue ?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:51 GMT-3