From: Ahmed Mamoor Amimi (mamoor@xxxxxxxx)
Date: Sat Feb 23 2002 - 17:25:01 GMT-3
yes ur right ..... u can do both ways....
-Mamoor
----- Original Message -----
From: <RSiddappa@NECBNS.com>
To: <mamoor@ieee.org>; <ccielab@groupstudy.com>
Sent: Sunday, February 24, 2002 1:03 AM
Subject: RE: RSRB & DLSW+ (............)
>
> Mammmor,
>
> I am little confused. Since R1 and R2 are alredy doing the briidng or DLSW
> stuff.
>
> I will take it like this, I need to connect two more routers at the end of
> each side and cofifgure this on those as end systems right.
>
>
> like this
>
> R3------to---------R1-------so-----------R2-------To--------R4
>
> R.
>
> -----Original Message-----
> From: Ahmed Mamoor Amimi [mailto:mamoor@ieee.org]
> Sent: Saturday, February 23, 2002 10:06 AM
> To: Siddappa, Rajeev; ccielab@groupstudy.com
> Subject: Re: RSRB & DLSW+ (............)
>
>
> DSPU will do the trick.
> It is PU communicating with the host (mainframe). and that is non-routable
> traffic of SNA.
>
> on R1 : (simulate host)
> dspu host test rmac xxxx.xxxx.xxxx lsap 6 dsap 6
> where xxxx.xxxx.xxxx is the mac address of R2 to0
> on interface To0
> dspu enable-host lsap 6
> dspu start test
>
> on R2 : (simulate PU)
> dspu PU test rmac xxxx.xxxx.xxxx lsap 6 dsap 6
> where xxxx.xxxx.xxxx is the mac address of R1 to0
> on interface To0
> dspu enable-pu lsap 6
> dspu start test
>
>
> Now issue command for Dlsw,RSRB to see if the circuit is established if so
> then ur config are correct as SNA
> non-routable have seen each other.
>
> for DSPU to check it have commnucated
> show dspu
> it will show u ACTIVE
>
>
> U can also test bridges also this way.... beware of cononical to
> non-cononical conversion.
>
> -Mamoor
>
>
> ----- Original Message -----
> From: <RSiddappa@NECBNS.com>
> To: <ccielab@groupstudy.com>
> Sent: Saturday, February 23, 2002 1:42 PM
> Subject: RSRB & DLSW+ (............)
>
>
> > I have following set up
> >
> >
> > To-------R1----/(serial)/---------R2 --------To
> >
> >
> > I do not have any end stations or any more token ring routers. How
> > do I test the
> >
> > RSRB and DLSW in different modes. (FST,TCP, direct..)
> >
> >
> > Thank you all in advance.
> >
> > R.
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:32 GMT-3