From: Ahmed Mamoor Amimi (mamoor@xxxxxxxx)
Date: Sat Feb 23 2002 - 13:19:14 GMT-3
If u router dont accept any break seqeuence at very startup then be calm u
have a bad console.
and the RS232 chip of console is dead which need replacement.... my 3
routers where dead like this
that they give on console but dont accept also not at the very begining....
if ur an electronic guy then u can desold that chip and replace it with the
sameone, before desolding
check the chip with a PROB. prob is an IC checker. u will see that signal is
coming but not going through it.
I am tell u all these things just because i have done it and replace the 232
chips and my router comes alive. u
have to do some research on this.
-Mamoor
----- Original Message -----
From: <CiscoCCNP3@aol.com>
To: <matthen@zisco.com.cn>; <ccielab@groupstudy.com>
Sent: Saturday, February 23, 2002 5:21 PM
Subject: Re: A MAD router
> hiya,
>
> what i would try is powercycling, and ctrl-break, the 2621 goes to ;
>
> rommon>
>
> then like you were going to do password recovery, bypass the startup
config
>
> rommon> confreg 0x2142
>
> after reload, the router will enter the intitial config dialogue, ctrl-c
to
> bypass that, and you'll have a clean router, reset to the correct baud
rate,
> and you can reconfigure, set enable pass etc.
>
> HTH
>
> joey r.
> ccnp/dp/si
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:31 GMT-3