From: Charles Manafa (charles.manafa@xxxxxxxxxxxxxxxx)
Date: Fri Feb 22 2002 - 18:25:31 GMT-3
don't you mean "source-bridge..."
----- Original Message -----
From: "Ahmed Mamoor Amimi" <mamoor@ieee.org>
To: "Tshon" <tshon@netzero.net>; "danyye" <danyye@yeah.net>
Cc: <ccielab@groupstudy.com>
Sent: Friday, February 22, 2002 4:56 PM
Subject: Re: how configure a vitual token ring on ethernet interface
> u have mistyped the command : source-group transparent 100 70 1 10
> and also on token ring beware of 2 things :
> 1- bit-swap
> 2- multiring
>
> -Mamoor
>
> ----- Original Message -----
> From: Tshon <tshon@netzero.net>
> To: danyye <danyye@yeah.net>
> Cc: <ccielab@groupstudy.com>
> Sent: Friday, February 22, 2002 9:37 PM
> Subject: Re: how configure a vitual token ring on ethernet interface
>
>
> > try cisco press IBM networks.
> >
> > source-group ring-group 100 (this makes a virtual ring)
> > source-group 100 70 1 10
> >
> > ethernet 0
> > bridge-group 10
> >
> > token 0
> > source-group 8 1 100
> >
> > this says that token 0 is in ring 8 bridge 1 and should place the source
> > route
> > the traffick to ring 100.
> >
> >
> > the global portion says that virtual ring 100 (same as everywhere above)
> > should source route the traffick to pseudo ring 70... you will not find
a
> > pseudo ring anywhere that references the 70.... it represents the
> > brigde-group 10
> > .....bridge 1.
> >
> > danyye wrote:
> >
> > >hi:
> > >how configure a vitual token ring on ethernet interface,where find some
> > >more configuration?
> > >danyye
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:31 GMT-3