From: Xuan.Sun@xxxxxxxxxxx
Date: Wed Feb 20 2002 - 20:34:07 GMT-3
When you use "sh int tunnel 0", you will see "keepalive not set". Do you
know how to enable it? Does it mean the tunnel will send a keepalive to
track the tunnel interface up/down?
"Ahmed Mamoor Amimi" <mamoor@ieee.org>@groupstudy.com on 02/20/2002
02:47:21 PM
Please respond to "Ahmed Mamoor Amimi" <mamoor@ieee.org>
Sent by: nobody@groupstudy.com
To: "Tarek Sabry" <tsabry@houston.sns.slb.com>, <ccielab@groupstudy.com>
cc:
Subject: Re: EIGRP and Tunnels
Tarek,
GRE tunnel is so cooool thing that u can do anything with it.
> - run EIGRP on a GRE tunnel?
Yes u can !
> - transport my static local routes across this MPLS cloud this way?
Yes u can !
> - use a VLSM network in EIGRP like I did?
Sorry pal u can't !
If ur running 12.1 IOS then by using MASK in eigrp u can do that too.
GRE will simulate on the other end that the remote networks are connected
just after the tunnel interface. U can use tunnel accross anything ,
condition is that the network should be of IP.
-Mamoor
----- Original Message -----
From: Tarek Sabry <tsabry@houston.sns.slb.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, February 20, 2002 9:17 PM
Subject: EIGRP and Tunnels
> Hi
>
> Does the following make sense:
>
>
> ------<R1)>-----(tunnel1)
--------------------------MPLS-------------------
-- > -(tunnel1)-----<R2>--- > > where on R1: > --------------------------------------------------------------------- > ... > ... > interface tunnel1 > ip address 192.168.30.49 255.255.255.248 > tunnel source x.x.x.x > tunnel destination x.x.x.x > ... > ... > router eigrp 1 > network 192.168.30.48 > redistribute static > ... > ... > -------------------------------------------------------------------- > > In other words, can I: > > - run EIGRP on a GRE tunnel? > - transport my static local routes across this MPLS cloud this way? > - use a VLSM network in EIGRP like I did? > > Thanks a lot > Tarek
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:29 GMT-3