From: John Neiberger (neiby@xxxxxxxxxx)
Date: Tue Feb 19 2002 - 12:12:13 GMT-3
According to the following link:
http://www.cisco.com/warp/public/104/dcprob.html
...your links must either be point-to-point or point-to-
multipoint. Any other link type will not work correctly. In
your config below, I'm not sure which information is current.
Your config shows that have point-to-point configured, while
the output of show ip ospf int says that it is set to non-
broadcast.
If the line is flapping due to changes in the OSPF database,
try using 'debug ip ospf monitor' to hunt down the misbehaving
LSAs.
Regards,
John
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:27 GMT-3