From: Shailen Amichand (Shailen.Amichand@xxxxxxxxxx)
Date: Mon Feb 18 2002 - 00:17:25 GMT-3
Yep this is possible on 12.0 IOS but not in 12.1 from my experience.
Shailen
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Lab Candidate
Sent: Monday, 18 February 2002 12:23
To: Chuck Church; 'ietobe'; 'ccielab@groupstudy.com'
Subject: RE: Why can't I set ip add on virtual-tokering interface
I did put ip address on my Virtual Token interface. see below:
r1#conf t
Enter configuration commands, one per line. End with CNTL/Z.
r1(config)#int virtual-TokenRing 1 r1(config-if)#ip addr 10.1.1.5
255.255.255.0 r1(config-if)#en r1#sh ip int b
00:12:46: %SYS-5-CONFIG_I: Configured from console by consolent
Interface IP-Address OK? Method Status
Protocol
Ethernet0 10.1.8.1 YES manual up
up
Serial0 unassigned YES unset administratively down
down
Serial1 unassigned YES unset administratively down
down
Virtual-TokenRing0 10.0.0.1 YES manual up
up
Virtual-TokenRing1 10.1.1.5 YES manual up
up
r1#
--- Chuck Church <cchurch@MAGNACOM.com> wrote:
> ietobe,
>
> I don't think virtual TR interfaces will take any layer 3
addresses.
> Their intended use is bridging commands.
>
> Chuck
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> ietobe
> Sent: Sunday, February 17, 2002 2:30 AM
> To: ccielab@groupstudy.com
> Subject: Why can't I set ip add on virtual-tokering interface
>
>
> router(config-if)#ip add 10.1.1.1 255.255.255.0
>
> % IP addresses may not be configured on a Virtual-TokenRing interface.
>
>
> ios version: c4500-ds-mz.121-13.bin
>
>
> Tks advance
>
>
> ietobe
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:26 GMT-3