From: Williams, Glenn (WILLIAMSG@xxxxxxxxxxxxx)
Date: Fri Feb 15 2002 - 11:59:24 GMT-3
Depends if it is on. If a FR physical, it will be off.
GW
-----Original Message-----
From: Steven Weber [mailto:itweber@earthlink.net]
Sent: Friday, February 15, 2002 8:54 AM
To: Williams, Glenn; Church, Chuck; ccielab@groupstudy.com
Subject: Re: distribute lists in IS-IS........
William,
you bring up a good point, why is ISIS seeing it's own routes from EIGRP in
the first place, split horizon should prevent that from being sent back in
shouldn't it ?
Steve
----- Original Message -----
From: "Williams, Glenn" <WILLIAMSG@PANASONIC.COM>
To: "'Steven Weber'" <itweber@earthlink.net>; "Church, Chuck"
<cchurch@USTA.com>; <ccielab@groupstudy.com>
Sent: Friday, February 15, 2002 9:13 AM
Subject: RE: distribute lists in IS-IS........
> Wouldn't either split horizon or dist list out on the part of EIGRP work?
> If ISIS I imagine you are trying to use dist list in at interface or dist
> list out in the ISIS routing protocol? Which way in ISIS did not work?
>
> GW
>
> -----Original Message-----
> From: Steven Weber [mailto:itweber@earthlink.net]
> Sent: Thursday, February 14, 2002 2:41 PM
> To: Church, Chuck; ccielab@groupstudy.com
> Subject: Re: distribute lists in IS-IS........
>
>
> I was trying to filter routes that were redistributed into EIGRP from
coming
> back into ISIS
> ----- Original Message -----
> From: "Church, Chuck" <cchurch@USTA.com>
> To: "'Steven Weber'" <itweber@earthlink.net>; <ccielab@groupstudy.com>
> Sent: Thursday, February 14, 2002 3:34 PM
> Subject: RE: distribute lists in IS-IS........
>
>
> > Steven,
> >
> > Remember, ISIS is a link state protocol. You can't filter between
> > routers of the same area because their link state databases must be the
> > same. Same as NLSP or OSPF. Was that what you were trying to do?
> >
> > Chuck
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > Steven Weber
> > Sent: Thursday, February 14, 2002 12:32 PM
> > To: ccielab@groupstudy.com
> > Subject: distribute lists in IS-IS........
> >
> >
> > I can't seem to get distribute lists working in ISIS. When I type the
> > command
> > in the router accepts it but when I check the config it's not in there,
> nor
> > is
> > the filtering working. Does ISIS not support distribute lists ?
> >
> > -Steve
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:23 GMT-3