From: MOLINA, MARTIN J *Internet* (PBI) (mm1343@xxxxxxx)
Date: Thu Feb 07 2002 - 14:47:06 GMT-3
Make sure there are no /32 routes appearing in your route table for the BRI
network. If there are, I believe the no peer neighbor-route command issued
on the BRI interface will take care of the issue. I could be wrong.
-----Original Message-----
From: jim.phillipo@guardent.com [mailto:jim.phillipo@guardent.com]
Sent: Thursday, February 07, 2002 9:04 AM
To: ccielab@groupstudy.com
Subject: OSPF Demand Circuit issues Boot Camp lab 5b
I have a OSPF demand circuit set up between router 5 and 6. The demand
circuit is running over ISDN. Both routers are in area0.
Show IP OSPF interface BRI0 indicates that it is running as a demand circuit
and Hello's will be surpresssed. Sho IP OSPF neighbor confirms this. The
dead intervals are not listed for each neighbor.
The problem is the circuit keeps going up and down. Show dialer indicates
the reason is 224.0.0.5 is bringing up the line.
Any thoughts ?
Jim Phillipo, CCNP, CCDP
Sr. Internetworking Engineer
W: 401.456.1821 F: 401.456.0599 M: 781.983.0316
90 Royal Little Drive, Providence, RI 02904
www.guardent.com
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:14 GMT-3