From: Erhan Kurt (iekurt@xxxxxxxxx)
Date: Mon Feb 04 2002 - 11:24:38 GMT-3
Hi All,
Below config works well with a rollover cable.
Caller:
interface Async241
ip address 192.168.1.1 255.255.255.0
encapsulation ppp
ip ospf demand-circuit
dialer in-band
dialer-group 1
async default routing
async dynamic routing
async mode dedicated
ipx network 63
no ipx route-cache
no fair-queue
no cdp enable
ppp authentication chap callin
!
Called:
interface Async241
ip address 192.168.1.2 255.255.255.0
encapsulation ppp
ip ospf network point-to-point
ip ospf demand-circuit
async default routing
async dynamic routing
async mode dedicated
ipx network 63
no fair-queue
no cdp enable
ppp authentication chap
!
Cheers,
Erhan
--- JOSE ANGEL MARTINEZ DE LA VARA
<jamartinez@landata.payma.es> wrote:
> Hi,
>
> I've tried that and works with a roll-over cable
> (cisco console cable). You
> have to create the async interface with the number
> os line for the aux shown
> in the show line command. I think it is
> automatically created when you enter
> the command modem inout in the line.
>
> After those commands and some more that you can find
> at cco
>
http://www.cisco.com/warp/public/793/access_dial/auxback.html
> and
> successfull ping when cofiguring the physical
> interface as Legacy-DDR, the I
> tried to use Dialer and never worked. Never
> apperared the dialer bind to the
> physical interface when pinging as before with debug
> dialer enabled.
>
> Tell me if you succed.
>
> Good luck
>
> Jose Angel
>
> -----Mensaje original-----
> De: Carl Phelan [mailto:carlphelan@hotmail.com]
> Enviado el: viernes, 01 de febrero de 2002 20:47
> Para: ccielab@groupstudy.com
> Asunto: AUX to AUX Dialer - as ISDN
>
>
> Hi,
>
> It's probably been discussed many times already but
> not easily found in
> the archives.
>
> I'm looking for the best configuration or paper that
> will show how to
> simulate ISDN callout as near as possible over an
> AUX to AUX connection
> - I understand with a straight through cable. If
> possible, it will
> allow you work up through layers 2 and 3.
>
> Many thanks.
>
> Carl.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:11 GMT-3