From: Stephen Oliver (stevie_oliver@xxxxxxxxxxx)
Date: Sun Feb 03 2002 - 15:05:20 GMT-3
I'm trying to do a "simple" SR/TLB scenario to help my limited understanding
of this subject.
I have a router with a TR port and an ethernet port and I'm hanging a router
off each to simulate a host. I've given them an address on the same subnet
and I'm trying to bridge via the router between them.
I've done
# no ip routing
#source-bridge ring-group 2000
#source-bridge transparent 2000 1000 1 1
# int e0
# bridge-group 1
#int to0
#source-bridge 55 1 2000 55 is the external ring I have hung a host on
#source-bridge spanning
# bridge 1 prot ieee
The host routers just have IP addresses on the appropriate interfaces and
I'm trying to ping between them but no success.
The ethernet and token ring interfaces work fine if I turn on ip routing on
the bridge, give them an appropriate ip address and ping to the host
attached to the interface.
Where is my limited source-route knowledge going wrong ?
Many thanks, Stephen.
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:10 GMT-3