From: Bryan Ginman (ginmanb@xxxxxxxxxxx)
Date: Fri Feb 01 2002 - 12:55:05 GMT-3
looks like the url below is tied to a cookie, try here www.craftsman.com and
type Damaged Screw Remover in the search.
Cheers,
Bryan
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Bryan Ginman
Sent: Friday, February 01, 2002 9:21 AM
To: Steven Weber; Giveortake@aol.com; ccielab@groupstudy.com
Subject: RE: 25xx Good Laugh
try this best tool I ever bought. Watch the wrap
http://www.sears.com/sr/craftsman/whatsnew/cr_ct_cooltooldetail.jsp?BV_Sessi
onID=@@@@1575651870.1012572918@@@@&BV_EngineID=ffadcdeiihjgjbggcmgclchn.0&ve
rtical=TOOL&Tool_Id=14
Damaged Screw Remover
Disclaimer: I have no affiliation with Sears or Craftsman.
Cheers,
Bryan
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Steven Weber
Sent: Friday, February 01, 2002 8:22 AM
To: Giveortake@aol.com; ccielab@groupstudy.com
Subject: Re: 25xx Good Laugh
Tell me about it, I did the same thing with my Cat5K and now it seems to be
stuck in my rack for life.
----- Original Message -----
From: <Giveortake@aol.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, January 31, 2002 6:36 PM
Subject: 25xx Good Laugh
> Well now I've done it.. I tried to put an image on a router with
> insufficient DRAM. So now it wont boot. I can ctrl break, but I dont get
> the standard RMON> prompt. Instead I get a ">" with nothing else. Very
> limited options available. None of the typical confreg or xmodem
commands.
> Thus I can't figure out how to fix my problem. CCO search for
25xx
> gave the typical RMON disaster recovery options but none of them apply.
> Bootstrap is 5.2(5).
>
> Now here is the funny part: I figured no problem I will just yank the
dram
> from another machine and dowgrade IOS. Well its in my rack and apparently
I
> tightened it down to hard. Stripped the screws and now I can't get it out
> without a drill. I broke all my drill bits on the last one I had to get
out
> of there.
>
> Moral to the story: HAND TIGHTEN YOUR RACK SCREWS. Do not use a power
> screwdriver!!!!!!!
>
> Anyone have any suggestions??
>
> David
This archive was generated by hypermail 2.1.4 : Thu Jun 20 2002 - 13:46:09 GMT-3