From: Bob Grafals (bgrafals@xxxxxxxxxxx)
Date: Sun Jan 13 2002 - 22:16:00 GMT-3
Whoops! I forgot to add the output from the show flash on the previous
message.
I've been trying to load an image that's approximately 13 MB on my 3640. It
loads about 8 meg of the image and then fails. Basically I'm getting an error
message that says that the flash is out of room. I can do a show flash at
that point and the system says that there are roughly 8 mb has been used and 8
mb are free. Images of less than 8 meg are no problem.
It almost seems as though I only have 8 meg of flash in the router. The
following output from show flash does indeed say that I have 1 partition of 16
meg. The only discrepancy that I can see is that the bank-size is only 4 meg.
My other routers are of the 2500 series and they all show a bank-size of 8 mb.
Any ideas?
Thanks,
Bob
r1#sh flash all
Partition Size Used Free Bank-Size State Copy Mode
1 16384K 5782K 10601K 4096K Read/Write Direct
System flash directory:
File Length Name/status
addr fcksum ccksum
1 5921084 c3640-i-mz.122-3.bin
0x40 0xA978 0xA978
[5921148 bytes used, 10856068 available, 16777216 total]
16384K bytes of processor board System flash (Read/Write)
Chip Bank Code Size Name
1 1 89A2 1024KB INTEL 28F008SA
2 1 89A2 1024KB INTEL 28F008SA
3 1 89A2 1024KB INTEL 28F008SA
4 1 89A2 1024KB INTEL 28F008SA
1 2 89A2 1024KB INTEL 28F008SA
2 2 89A2 1024KB INTEL 28F008SA
3 2 89A2 1024KB INTEL 28F008SA
4 2 89A2 1024KB INTEL 28F008SA
1 3 89A2 1024KB INTEL 28F008SA
2 3 89A2 1024KB INTEL 28F008SA
3 3 89A2 1024KB INTEL 28F008SA
4 3 89A2 1024KB INTEL 28F008SA
1 4 89A2 1024KB INTEL 28F008SA
2 4 89A2 1024KB INTEL 28F008SA
3 4 89A2 1024KB INTEL 28F008SA
4 4 89A2 1024KB INTEL 28F008SA
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:27 GMT-3