From: Albert Lu (albert_ccie@xxxxxxxxx)
Date: Thu Jan 10 2002 - 20:55:53 GMT-3
Brian,
Hey, that's a good idea.
I would also add the points for each section, and also a time column.
Device R1 R2 R3 R4 R5 Cat5 Time
Section
1.1 (4) x x 30m
1.2 (1) x x x x 15m
1.3 (2) x x 10m
2.1 (1) x x 20m
Obviously the time column has to be an estimation. I would base it on
completing the lab in 6hours, dividing into the way Caslow divides the
different Levels.
You would have to force yourself to move on if you have not completed the
section in the allocated time. Of course, you would have to take into
consideration that you can't really move on to sections that are dependent
on other sections (eg. if FR is not working, IP will not work).
Why 6 hours? I feel 6 hours is doable, and when you finish the lab with 2
hours to spare, there is alot less pressure and allows for you to switch
hats an pretend to be a proctor to pick apart your configs.
Also, finishing the lab in 6 hours does not mean you blindly type in the
configs and hope that it works in the end. It means you have 90% certainty
that it is correct, and you have tested each section.
Albert
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Brian Dennis
Sent: Friday, January 11, 2002 8:14 AM
To: ccielab@groupstudy.com
Subject: RE: at the lab exam
You also could make a sort of table to use while reading over the lab. Mark
down which devices need to be configured for each section. Then as you do
the sections mark off (i.e. circle) what devices have been done. See below:
Device R1 R2 R3 R4 R5 Cat5
Section
1.1 x x
1.2 x x x x
1.3 x x
2.1 x x
A student of mine came up with this idea and I thought it was pretty cool.
Brian Dennis, CCIE #2210 (R&S)(ISP/Dial) CCSI #98640
5G Networks, Inc.
brian@5g.net
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Mas Kato
Sent: Thursday, January 10, 2002 12:44 PM
To: yusman@mastersystem.co.id
Cc: ccielab@groupstudy.com
Subject: RE: at the lab exam
[demime could not interpret encoding binary - treating as plain text]
I would suggest reading through the whole assignment not just once, but
twice before charging in. On the first pass, look for issues and order
dependencies. On the second pass look for absolutes--absolute values to be
used, ranges to be covered, etc.--note these and then go for it!
Best of luck,
Mas Kato
https://ecardfile.com/id/mkato
> Yusman@mastersystem.co.id at the lab exam ccielab@groupstudy.comDate: Thu,
10 Jan 2002 18:31:05 +0700
>Reply-To: Yusman@mastersystem.co.id
>
>For the first attempt lab exam, what is the best, read the whole lab
>instruction then do the lab or read per section task then do the test,
>without wasting the time
>
>Thanks for the opinion
------------------------------------------------------------
Speed Racer's Official Virtual Pit Stop.
http://www.speedracerdsl.com/speedracer/
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:23 GMT-3