From: Wen Jia Yang (tonyblair@xxxxxxxxx)
Date: Wed Jan 09 2002 - 03:32:19 GMT-3
Hi,dear group members:
when I issue write erase and reload
without saving config
then after restart,I issued
confi t
int e0
no keep
then after I run a show int s0
I found the keepalive value(default is 10 seconds)has been erased too.
But I didn't use that command on the serial interface,I just do that on my ethe
rnet interface.
the router model is a 2514,I just used ethernet0
anyone offer a hand?Thanks in advance.
the version info is as followed:
Cisco Internetwork Operating System Software
IOS (tm) 2500 Software (C2500-JS56I-L), Version 12.0(7), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-1999 by cisco Systems, Inc.
Compiled Thu 14-Oct-99 01:19 by phanguye
Image text-base: 0x0000144C, data-base: 0x009D67D8
ROM: System Bootstrap, Version 5.2(8a), RELEASE SOFTWARE
BOOTFLASH: 3000 Bootstrap Software (IGS-RXBOOT), Version 10.2(8a), RELEASE SOFT
W
ARE (fc1)
r1 uptime is 22 minutes
System restarted by reload
System image file is "flash:C25l1207.mz"
cisco 2500 (68030) processor (revision L) with 14336K/2048K bytes of memory.
Processor board ID 02307937, with hardware revision 00000000
Bridging software.
X.25 software, Version 3.0.0.
SuperLAT software (copyright 1990 by Meridian Technology Corp).
TN3270 Emulation software.
2 Ethernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:21 GMT-3