From: Jason Atkins (Jason_Atkins@xxxxxxxxxxxx)
Date: Wed Jan 09 2002 - 02:30:21 GMT-3
THe questions basically wants you to use Subinterfaces on R1 (point to
point or Multipoint) and normal interfaces on R2,R3 and R5.
Looking at the diagram you will need to configure a multipoint subinterface
on R1 for the connections to R3 and R5. R1 to R2 could be either point to
point or multipoint.
Jason Atkins
Network Engineer
Data#3 Limited
Mobile: 0411 725 691
"Steve Barone"
<steve@chetona To: ccielab@groupstudy.com
.com> cc:
Sent by: Subject: Bootcamp #2, FR config
nobody@groupst
udy.com
09/01/2004
03:57 PM
Please respond
to "Steve
Barone"
Group,
I am confused on how to determine from the question whether the interface
should be a point-to-point or multipoint. When they say use two
subinterfaces, can I use two multipoint interfaces?
When they say "use only one PVC on R2, R3 and R5", does this mean I can
use one frame relay map statment per spoke, to the hub?
Thanks
Steve
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:21 GMT-3