From: Geralt Omhof (geralt@xxxxxxxx)
Date: Sun Jan 06 2002 - 17:23:19 GMT-3
I've just upgraded a 2503 router with an extra 8mb flash (16mb total now). With
the second flash module the router displays the following when a "show version
"is performed. Can anyone tell me how to make the flash programmable? I've chec
ked the archives and someone mentioned to use RSL. I've tried that but it also
refuses to load any ios image in the flash.....
Thanks in advance,
Geralt
Cisco Internetwork Operating System Software
IOS (tm) 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE SOFTW
A
RE (fc1)
Copyright (c) 1986-1996 by cisco Systems, Inc.
Compiled Fri 27-Dec-96 17:33 by loreilly
Image text-base: 0x01010000, data-base: 0x00001000
ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
Router uptime is 21 minutes
System restarted by power-on
Running default software
Host configuration file is "rsl-router-startup.cfg", booted via tftp from 169.2
5
4.140.46
cisco 2500 (68030) processor (revision N) with 14336K/2048K bytes of memory.
Processor board ID 06910116, with hardware revision 00000001
X.25 software, Version 2.0, NET2, BFE and GOSIP compliant.
Basic Rate ISDN software, Version 1.0.
1 Ethernet/IEEE 802.3 interface.
2 Serial network interfaces.
1 ISDN Basic Rate interface.
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Device not programmable)
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:17 GMT-3