From: Scott Morris (swm@xxxxxxxxxx)
Date: Fri Jan 04 2002 - 19:05:28 GMT-3
DLCI's are actually GENERATED by the frame switch. So if you have some you
don't want, change them at the switch level.
The ONLY reason you put DLCI information on your router is when you are
using sub-interfaces, so you give the information someplace logical to go.
HTH
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Robert DuBell
Sent: Friday, January 04, 2002 11:44 AM
To: ccielab@groupstudy.com
Subject: DELETING UNWANTED DLCI'S
Is there a way to delete unwanted DLCI's from your router. I've tried
changing keepalive to 0 and using the no frame-relay interface-dlci command,
but that knocks down line protocol of course. I've tried about everything I
can find under the frame-relay commands and unable to delete unwanted DLCI's
from my router. Anybody run into this problem before ? I"ve searched the
archives and cannot find an answer to this problem (if there is one
)....Thanks...Bob
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:16 GMT-3