From: Denise Donohue (fradendon@xxxxxxxx)
Date: Fri Jan 04 2002 - 18:57:26 GMT-3
Here's the trick - you keep all your frame interfaces shut until they are
all configured. Go to each one and tell it "no frame inverse-arp". Put
whatever mappings you'll need on the interfaces also. Only after you have
configured EVERY ONE of the frame interfaces on EVERY router do you go back
to each one and "no shut" them. The PVC's will still show up under "show
frame pvc" but they'll be unused or inactive.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Robert DuBell
Sent: Friday, January 04, 2002 11:44 AM
To: ccielab@groupstudy.com
Subject: DELETING UNWANTED DLCI'S
Is there a way to delete unwanted DLCI's from your router. I've tried
changing keepalive to 0 and using the no frame-relay interface-dlci command,
but that knocks down line protocol of course. I've tried about everything I
can find under the frame-relay commands and unable to delete unwanted DLCI's
from my router. Anybody run into this problem before ? I"ve searched the
archives and cannot find an answer to this problem (if there is one
)....Thanks...Bob
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:56:16 GMT-3