From: paul jin (pauljin@xxxxxxxxx)
Date: Fri Dec 28 2001 - 22:04:05 GMT-3
>From the looks of the diagram, I think you might have the DLCIs reversed. You
have DLCI 912 going towards,
R3 and you have DLCI 913 going towards R2. I think you were meaning to point 9
13 towards R3 and
912 towards R2.
If you check the addressing assignment between the PVCs, they are not on the s
ame subnet, thus you are
getting the message.
For example, S0.2 with address of 10.1.155.1/30 DLCI 912 seems to go towards R3
and the R3
address is 10.1.155.6/30 instead of .2. And it looks like the other PVC has th
e same problem.
Paul
"A.Steinbock" <anja10@usa.net> wrote: I am yet to figure out why I am getting
this message on a very simple
frame-relay+Eigrp setting.
Here is the diagram and router configs:
http://24.234.55.18/out/eigrp.jpg
The frame switch config is:
!
interface Serial1
no ip address
encapsulation frame-relay
clockrate 56000
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 912 interface Serial2 921
frame-relay route 913 interface Serial3 931
frame-relay route 914 interface Serial4 941
frame-relay route 915 interface Serial5 951
frame-relay route 916 interface Serial6 961
frame-relay route 917 interface Serial7 971
!
interface Serial2
no ip address
encapsulation frame-relay
clockrate 56000
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 921 interface Serial1 912
frame-relay route 923 interface Serial3 932
frame-relay route 924 interface Serial4 942
frame-relay route 925 interface Serial5 952
frame-relay route 926 interface Serial6 962
frame-relay route 927 interface Serial7 972
!
interface Serial3
no ip address
encapsulation frame-relay
clockrate 56000
frame-relay lmi-type cisco
frame-relay intf-type dce
frame-relay route 931 interface Serial1 913
frame-relay route 932 interface Serial2 923
frame-relay route 934 interface Serial4 943
frame-relay route 935 interface Serial5 953
frame-relay route 936 interface Serial6 963
frame-relay route 937 interface Serial7 973
!
on R2 I get the message:
01:38:16: IP-EIGRP: Neighbor 10.155.1.6 not on common subnet for Serial0
on r3 I get the message:
01:38:53: IP-EIGRP: Neighbor 10.155.1.2 not on common subnet for Serial0
I've checked CCO. although there is an explanation for it at
http://www.cisco.com/warp/public/103/15.html
but I can not relate.
Can some one shed a light Please?
TIA
Akim
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:32:49 GMT-3
